Results You searched for: ALEX (Aluminum Extrusion) Reflector Assembly Housing for Ceramic Infrared Heaters Results Displayed: 1 - 27 of 27
ALEX (Aluminum Extrusion) Reflector Assembly Housing for Ceramic Infrared Heaters
Our ALEX reflectors are designed to use our FT Size Ceramic Infrared Heaters which are 96% infrared energy efficient. Our standard ALEX reflectors are a complete reflector assembly with reflector, outer case and terminal blocks and they can be mounted in any direction, or side by side to make a larger panel.
Please note, the ALEX Assemblies are for use in industrial process heating applications only (not to be used in residential or commercial heating applications).
They are pre-wired for FT type ceramic emitters and cannot be used with our FF, HT, HF, QF or HS type ceramic emitters. They require at least the standard 6" (152.4mm) leads with pin terminals. The outer case is extruded aluminum and the reflector is polished stainless steel. Our replaceable thermocouple does not fit in our ALEX reflector assemblies. Use our FRK thermocouple instead.
The electrical conduit can be connected to either end since they have a removable hole plug in the end cap. There is a green ground screw in the terminal connection area and one or more TB-2 terminal block connections
• 1/2" conduit knockout. • More durable and sturdy extruded aluminum. • Stainless steel reflectors resist corrosion better. • Built-in interlocking channel. A channel on each side of the extrusion allows them to be interlocked together using 16 gauge sheet metal. By customizing the size of the sheet metal pieces, and the angles that they are placed, an oven can be constructed.
Position Adjustable Mounting System
Standard mounting via a 1/4-20x1.5 stud, 2 hex nuts, lock washer and 2 washers
Adjustment for mounting hole spacing is possible because the stud screws into a t-slot nut with a ball/spring, which slides in the groove of the top terminal cover extrusion.
1. Alex: Terminal Cover Extrusion 2. Alex: H Section Extrusion 3. Alex: End Cap 4. Alex: Hole Plug For End Cap 5. TB-2 Ceramic Terminal Block 6. Alex: Ref-1 (Reflector) 7. Stand-Off 8. Screw: #8-32xl.25" 9. Screw: M5x30 10. Hex Nut: #8 11. Hex Nut: M5 12. Screw: #8x.25 Type-B 13. Green Ground Screw: #10-32x.375 14. 1/4-20 T-Slot Nut With Ball/Spring 15. 1/4-20x1.5 Stud, Hex Nuts And Washers
ALEX-F A = 10" (254 mm) long for one FT heater
Optional Wire Guards for ALEX reflectors
Wire guard protection is available to protect the heaters from damage.