Home >> Roof & Gutter Deicing >> SureBond SB-1800 Everflex Bondaprene Adhesive used to adhere plastic or metal roof clips to metal roofs
Results You searched for: SureBond SB-1800 Everflex Bondaprene Adhesive used to adhere plastic or metal roof clips to metal roofs Results Displayed: 1 - 1 of 1
Surebond SB-1800 Everflex Bondaprene
Surebond SB-1800 Everflex Bondaprene is used to adhere plastic or metal roof clips to METAL ROOFS ONLY. This product is NOT designed to be used with asphalt shingles. A tube of Surebond is estimated to be enough to adhere 20 RCK or ZH-C roof clips.
Application and Cleaning
Interface and surfaces must be clean, dry and free of dust, dirt, oil, frost, moisture and water proofing and release agents. All painting should be done before application. Cut cartridge nozzle for 3/8" hole and puncture inner seal, apply bead size as desired. Always apply uniform bead and tool immediately after application to ensure full contact with both sides of the joint area. Squeeze out should not occur on most overlap seals applied properly. Sealant starts to skin over in five to ten minutes and dries to the touch within an hour.
Unopened containers should be stored for up to nine months at 60ºF to 70ºF, 50% R.H. in a cool, dry area.
10.3 oz. cartridge
For industrial use only. Skin and eye irritant. Harmful if swallowed. Avoid contact with or breathing in of vapor and use adequate ventilation. Material on skin should be wiped and washed off with soap and water. For eyes, flush with water and seek medical attention. SEE MATERIAL SAFETY DATA SHEET, a link is provided below.
Wide Application Temperature
Protects Welds From Corrosion
Minimizes Dirt and Dust Pick Up, Expedited Production
Product Maintains Integrity and Flexibility in Service Temperature Range
Can be Applied From -20ºF to Over 140ºF
Reduces Product Need by 50%
Allows For Panel and Overhead Applications
Will Not Discolor Materials
Tack Time 40-60 Minutes TT-S-00230C Test Method
Cure Time 24 Hours Using 1/8" Bead
Tensile Strength 360 PSI ASTM-D412 Test Method
Service Temperature, Cured -80ºF to +480ºF TT-S-00230C Test Method
Elongation 450% fully cured ASTM-D412 Test Method
Staining None TT-S-00230C Test Method
Hardness, Shore A 28 TT-S-00230C Test Method
All Values Are Typical at 75ºF, 50% R.H. Unless Otherwise Noted
Federal Specifications TT-S-00230C Used When Applicable